Drivedx s.m.a.r.t. status improve4/28/2023 ![]() ![]() How do I go about this Thunderbolt outage? Below is the System Report from the iMac. So I guess I have a bad Thunderbolt port on the iMac? A firmware issue? Interactive help hints for all drive health indicators (SMART attributes) Detects (HDD / SSD) drive health states: 4: 2: 3 / 2: OK: Warning: Failing (pre-fail) / Failed (one or more thresholds exceeded) HDD health status evaluation based on next criteria: built-in S.M.A.R.T. I followed all the steps to enable DriveDX access to my approved external drive, and got nowhere (i.e., back to the beginning). (Self-Monitoring, Analysis, and Reporting Technology,) which allows you to quickly see their health status. verifies SSD/HDD health status by inspecting the SMART status of the disks. The Thunderbolt bus system report on neither machine would show any device connected, when connected via the Thunderbolt Cable. Modern hard drives have a feature known as S.M.A.R.T. Hard Disk Sentinel monitors hard disk drive / HDD status including health. The iMac did not even seem to acknowledge the keypunches. Open DriveDX and you’ll get an overview of the drive, including an overall health rating, SMART status, and lifespan indicator. If you want to continue to use DriveDX past the two week trial, you can pay for it. Copernicus Sentinel-5 Precursor (S5p) products improvement - operational switch ESA releases new. DriveDX offers a free trial, allowing you to see the current health status of your SSD. When I was trying to connect the two computers via the Thunderbolt Cable, with an aluminum Apple Keyboard, with either CMD-F2, or CMD-fn-F2, I would not even get a computer screen flash or blink. This software utility monitors the HDD SMART status. Plugging a Lacie drive, Thunderbolt, into the iMac Thunderbolt, the drive does not power, or load, and on the Thunderbolt bus status, I get "No device connected" (does not change to "Device connected"). SMARTReporter is an application that can warn you of some hard disk drive failures before they actually happen It does so by periodically polling the S.M.A.R.T. ![]() Plugging a Lacie drive, Thunderbolt, into each port on the MacMini, the drive powers, loads, and I get "Device connected" on the Thunderbolt Bus System Report. STATUS IMPROVE FREE As opposed to such tools, DriveDx analyzes the current state of the drive using individual states all drive health indicators that are most likely to point to a potential drive issue. MacMini (a desktop) Late 2014 with two Thunderbolt ports (not MiniDV), firmware version 26.1 (not sure that matters), running 10.13.5 to connect with TARGET DISK MODE via APPLE 0.5m Thunderbolt Cable to a 21" iMac (mid 2011), with one Thunderbolt port (not MiniDV), firmware version d.16. Dreaded Target Disk Mode (ha) Thanks for looking.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |